A 3d printed truck i built last year. The chassis is a scx10.2 with RC4WD leaf spring conversion. Trans is a RC4WD R4 with GCM transfer case and uses AR44 axles. Steering is a tamyia bell crank system and the servo is under the interior. Tube work is a mix of brass tube and steel rod, i used the...
See MoreCraig Thompson (2 followers)
(skinanbones)
i drank the MEK
A truck i built several years ago. Full 3d printed body, with a engine underhood and full interior. Scx10 chassis that's now 13 inches, and laid out like a stock scx10. The truck held up well in a couple comps and now just hangs out on a shelf